I have found a work around on another thread for this issue.
I just did it on my windows 8.1 (MD802) and it works like a champ.
Follow Dagge's Instructions below
I have now found out that the problem is in Windows "security
settings". Standard setting in Windows 8.1 Pro (probaly the same in
other Win8-versions) is to stop drivers that are not approved by
Microsoft.
The driver included in the AUTEL PC Suite
Setup package is not digitally signed by Microsoft. To overcome this
problem I tested to tweak Windows according to this"Geek guide":
How to Disable Driver Signature Verification on 64-Bit Windows 8.1
----
Press the Win + C keyboard combination to bring up the Charms Bar, then click on the Settings Charm.
We need to head into the Modern Control Panel, so go ahead and click on the Change PC settings link.
When the Control Panel opens, switch over to the “Update & recovery” section.
Then click on the Recovery option on the left hand side.
Once
selected, you will see an advanced startup section appear on the right
hand side. You will need to click on the “Restart now”
button.(restarting and showing "Choose an option")
Once your Computer has rebooted you will need to choose the Troubleshoot option.
Then head into Advanced options.
Then Startup Settings.
Since
we are modifying boot time configuration settings, you will need to
restart your Computer one last time. (A list of "Restart to change
Windows options" will occur)
Finally, you will
be given a list of startup settings that you can change. The one we are
looking for is “Disable driver signature enforcement”. To choose the
setting, you will need to press the F7 key.
That’s all there is to it. Your PC will then reboot and you will be able to install unsigned drivers without any error message.
-------
Then I unistalled the AUTEL PC Suite.
Downloaded teh latest version again and installed successfully!
There was a WARNING during installation process, which I had to ignore (of course).
Now its possible to print out!
Might
be safeer to channge back Windows "security setting" again. Though I
have not done that yet. So I do not know if the print function will
remain afterwards....
Cheers!
Original post location:
http://pro.auteltech.com/autelsupport/MaxiService/16892.jhtml